Signal Generator Settings
R&S
®
SGS100A
97User Manual 1173.9105.02 ─ 12
"Save as"
Open the file menu to save the list under a new name.
Note: Save list only after filling both columns (frequency and level),
otherwise the entries are lost.
Each list is saved to the R&S SGS hard disk as a separate file with
the file prefix *.uco. The file name and the directory to which the file
is saved are user-selectable.
"Save"
The list is saved under its current name.
Remote command:
[:SOURce<hw>]:CORRection:CSET[:SELect] on page 244
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency on page 238
[:SOURce<hw>]:CORRection:CSET:DATA:POWer on page 239
Import/Export >>>
Expands the menu with the area for import and export of user correction files.
Externally edited Excel tables with any number of frequency/level value pairs can be
imported as text or *.csv files and used for user correction.
Conversely, you can also export internally created user correction lists as text or
*.csv files.
Mode
Selects if user correction lists should be imported or exported. The settings offered
depend on the selected mode.
Remote command:
[:SOURce<hw>]:CORRection:DEXChange:MODE on page 243
Extension
Selects the file extension of the ASCII file to be imported or exported. Selection "TXT"
(text file) or "CSV" (Excel file) is available.
Remote command:
[:SOURce<hw>]:CORRection:DEXChange:AFILe:EXTension on page 241
Decimal Point
Selects the decimal separator used in the ASCII data between '.' (decimal point) and ','
(comma) with floating-point numerals.
Remote command:
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:DECimal
on page 242
Column Separator
Selects the separator between the frequency and level column of the ASCII table the
user correction list is exported to or imported from.
Remote command:
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:COLumn
on page 242
Level and Power-On Settings
To Next Page
Loading...