Sam4s ER-920 - Saving Reports to an SD Card

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 S-Mode Programming • 105
Backing Up the Program to an SD Card
CAUTION: When backing up and restoring data, the store name must be programmed
in system option #30.
1. Turn the control lock to the S position.
2. To backup the program to SD, enter 1 0 0, press the SUBTOTAL key.
0
SUB
TOTAL
0 1
Restore Program from the SD Card
CAUTION: Memory allocation must be set the same as the saved program. Be sure to
print out the memory allocation so that it can be re-entered before restoring the
program.
1. Turn the control lock to the S position.
2. To load the entire program to the register from the SD card, enter 1 1 0, press
the SUBTOTAL key.
0
SUB
TOTAL
1 1
3. Beginning at software version 1.019, you can restore program areas separately.
Enter the 3-digit code from the table below and press the SUBTOTAL key.
Code Program Area Code Program Area
141
PLU only
142
Group only
143
Tax only
144
System only
145
Print only
146
Function key only
147
Clerk only
148
Logo only
149
FIN Report Logo
150
CLK Report Logo
151
Stock only
152
Macro only
153
MISC only
154
MNM only
Saving Reports to an SD Card
Reports saved are the current X1 readings. Reports can be saved in .rep file format (for use
by the PC Utility) or .csv file (can be opened in Microsoft Excel™. This feature is available
beginning at version 1.018.)
1. To save in .rep format, turn the control lock to the S position.
To save in .csv format, turn the control lock to the X position
2. To backup Reports to SD, enter 1 0 1, press the SUBTOTAL key.
1
SUB
TOTAL
0 1