Sam4s ER-920 - Program 80 - Function Key Descriptor

154 • P-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Program 80 - Function Key Descriptor
Program descriptors by typing descriptors on the alpha keyboard overlay or by
entering three digit alpha character codes. To enter descriptors by three digit alpha
character codes you must set system option #31 (See “System Option Programming” on
page 137).
Note: You can program descriptors up to 18 characters, however only the first 10 will
appear on the display.
1. Turn the control lock to the PGM position.
2. To begin the program, enter 8 0, press the SUBTL key.
3. If you are programming using an alpha keyboard overlay, type up to 18
descriptors on the overlay, press the X/TIME key and then press the function key
you are programming. (Note: As you are entering descriptors only the last 16
descriptors will display.)
If you are programming using descriptor codes, enter up to 18 three-character
codes and press the function key you are programming key. (See “Descriptor
Code Chart” on page 133.)
4. To program additional function keys, repeat from step 3, or press the CASH key
to finalize the program.
Descriptor Programs for the #/No Sale Key - Programs 80 & 81
Since two distinct functions, # entry and no sale, reside on the same key, different programs
are used to program each descriptor.
To program the no sale descriptor:
To program the # descriptor:
0 SUBTL8
Type up to 18
descriptor keys
X/TIME
CASH
Repeat for another function ke
y
FUNCTION
KE
Y
CASH SUBTL 0 8
Enter up to 18 descriptor codes, or
type 18 alpha overlay descriptors
Repeat for another function ke
y
FUNCTION
KE
Y
CASH SUBTL 1 8
Enter up to 18 descriptor codes, or
type 18 alpha overlay descriptors
Enter up to 18 three-
character codes
FUNCTION
KE
Y
FUNCTION
KE
Y