Sam4s ER-920 - Straight Percentage Tax Rate Programming

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 117
Straight Percentage Tax Rate Programming
Often, tax requirements may be met using a straight percentage rate. Use the following
method to program a tax as a straight percentage.
Important Note: Tax program procedures were updated at software version 1.019. At
this version it is no longer necessary to have multiple tax shift keys on the keyboard
when multiple taxes are used: all tax programming is done through the TAX 1 key.
Please use the appropriate instructions for the version you are programming.
Programming Straight Percentage Tax Rates and Status (Up to v1.017)
1. Turn the control lock to the PGM position.
2. If the tax is a percentage rate, with a decimal. (0.000-99.999). It is not necessary
to enter preceding zeros. For example, for 6%, enter 06.000 or 6.000.
3. For the type of tax:
If the tax is a percentage added to the sale (normal add on tax),
enter:
0
If the tax is a percentage value added tax (VAT; calculated as part of
the sale), enter:
2
4. Enter 0 here for all taxes, unless if you are programming tax 4 as a Canadian
GST. If tax 4 is a Canadian GST, enter the sum of the options below:
OPTION VALUE = SUM
GST (tax 4) is taxable by rate 1? Yes = 1
No = 0
GST (tax 4) is taxable by rate 2? Yes = 2
No = 0
GST (tax 4) is taxable by rate 3? Yes = 4
No = 0
5. Press the Tax key for the tax you are programming.
6. Press the CASH key to end programming.
Tax Rate Programming Flowchart
.
TAX
(
1/2/3/4
)
Tax Rate
You must enter decimal
GST
tax
Info
Tax
type
CASH