94 • S-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Clearing Memory
Memory All Clear
Before you use your ER-900 for the first time, you must perform a memory all clear to insure
that all totals and counters are cleared and that the default program is installed. Go to
“Clearing Memory” on page 26 to complete the procedure.
Clear All Totals and Counters
1. Turn the control lock to the S position.
2. Enter 20 and press the SUBTL key.
Clear Grand Total
1. Turn the control lock to the S position.
2. Enter 30 and press the SUBTL key.
Clear PLU File
1. Turn the control lock to the S position.
2. Enter 40 and press the SUBTL key. A confirmation dialog will ask “ARE YOU
SURE”. Press CASH to continue or CLEAR to abort the process.
3 0 SUBTL
2 0 SUBTL
4 0 SUBTL
To Next Page
Loading...
