Sam4s ER-920 - Log File Report

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 Integrated Payment Appendix • 231
To Execute a Diagnostic Test
The responses to the diagnostic commands are variable in content and not intended to be
interpreted by software. The printing of the diagnostic output is intended to have a human
operator read the results that will be readily interpreted with the assistance of a Datacap
support representative.
1. From Z-Mode: Enter 513, press SBTL.
2. Enter the diagnostic report number and then press CASH.
Log File Report
Z-Mode: Enter 514, press SBTL
The “Log File Report” is available beginning a software version 1.014. This report records
each time the “Issue Transaction” (report 506) is generated. When the “Log File Report”
reaches 20 entries, the error message “Log File Full” is displayed when a “Issue Transaction”
(report 506) is attempted. The “Log File Report” entries clear when the “Log File Report”
(report 514) is taken.
DAE 04/15/2007 WED TIME 08:27
Z 1 REPORT 00007
LAST REPORT 03/15/2007
-------------------------------
EFT TRANSACTION
1 04.15.07 08:27
GABRIEL STATUS ON
1 04.15.07 15:14
GABRIEL STATUS ON
1 04.15.07 20:27
GABRIEL STATUS ON
CLERK 1 NO.000118 00001