Sam4s ER-920 - Program 1200 - Check Change Limit Programming

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 199
Program 1200 - Check Change Limit Programming
Use this program to set the maximum amount of cash that can be returned when a check is
tendered for an amount greater than the amount of the sale. For example, if the check change
limit is $10.00 the maximum amount that can be tendered into the check key on a $5.00 sale
is $15.00.
Programming the Check Change Limit
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 2 0 0, press the SUBTL key.
3. Enter a cash-in-drawer limit (up to 8 digits or 0 for no limit); press the X/TIME
key.
4. Press the CASH key to finalize the program.
2 0 0 SUBTL1
CASH
X/TIME
Enter the cash
limit, up to 8
digits