Sam4s ER-920 - Program Scans

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 203
Program Scans
Since much time and energy has been invested in the planning and programming of your ER-
900, it is advisable to print a hard copy of the final program for future reference. This copy
should be kept in a safe place. (You can also save your program electronically, on a SD card.
Go to “Program Backup and Restore” on page 104 to use this method.)
1. Turn the control lock to the PGM position.
2. To print a program scan, enter 1 5, press the SUBTL key.
3. Refer to the chart below and enter a digit to represent the segment of the program
you wish to print; press the X/TIME key.
X Program X Program
0
Group
9
Financial Report message
1
Tax
10
Clerk Report message
2
System option
11
Macro Name
3
Print option
12
Drawer Limit
4
Function keys
13
Check Change Limit
5
Clerk
14
Time & Date
6
Preamble message
15
Tare Weight
7
Postamble message
16
Machine Number
8
Endorsement message
17
Mix & Match
4. To read PLU program information, enter the number of the first PLU in a range
of PLUs (up to 15 digits) that are to be scanned; press the PLU key. Enter the
last number in the range (up to 15 digits); press the PLU key, or
Pres the first PLU keys that are to scanned and Press the last PLU keys,
5. To read MACRO information, press the MACRO key to be scanned,
6. To read additional parts of the program, repeat from step 3, or press the CASH
key to finalize the program.
5
SUBTL1
X X/TIME
PLU PLU
PLU PLU
MACRO
CASH