Sam4s ER-920 - Memory Allocation Program

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 S-Mode Programming • 97
Memory Allocation Program
Once you have determined the memory variables you wish to set, you can set them in the
memory allocation program. If you attempt to allocate more options than memory, the
message “MEMORY ALLOCATION SIZE OVER” will print on the receipt and journal.
Setting memory allocation will require some trial and error; the register will not allow over-
allocation.
1. Turn the control lock to the S position.
2. To Allocate Memory, enter 6 0 and press the SUBTL key.
3. Refer to the chart below and enter a digit to represent allocated area and press the
X/TIME key.
4. Enter the desired
allocation.
Note for the CHECK
TYPE entry: enter 0
for soft check or enter 1
for hard check.
5. Repeat from step 3 to allocate another area, or press the CASH key to finalize the
program. If the allocation is accepted, the printer will print the new allocation. If
the allocation is not accepted, the message “ALLOCATION OVER” will display.
X Allocated Area
1
PLU
2
CLERK
3
GROUP
4
CHECK#
5
SOFT CHECK LINES
6
CHECK TYPE : Hard(1), Soft(0)
7
# of PRICE LEVELS
8
MIX & MATCH
9
ELECTRONIC JOURNAL LINES
X X/TIME
CASH
0
SUBTL6
CASH