SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 127
Program 110 - PLU Auto Tare Programming
Note: Tare #5 can be used for open tare entries.
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 1 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
Press a PLU key on the keyboard or scan the item.
If sequential PLUs are to receive the same status, press the first PLU key and
then press the last PLU key.
Enter the number of the PLU (up to 15 digits) and press the PLU key.
Enter the number of the first PLU in a range of PLUs that are to receive the
same setting; press the PLU key. Enter the last number in the range; press
the PLU key.
4. Enter a value (1-5) to indicate the number of the preprogrammed tare weight you
want to automatically subtract when the PLU is used for scale entry (using an
optional scale), and then press the X/TIME key. Enter 0 to disable automatic tare
subtraction.
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
1 1 0 SUBTL
PLU
PLU PLU
PLU
PLU PLU
CASH
X/TIME
To Next Page
Loading...
