Sam4s ER-920 - System Option Table

138 • P-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
System Option Table
Note: Default Values are shown in bold type.
Address SYSTEM OPTION VALUE = SUM
1
Beeper is active?
Yes = 0
No = 1
Reserved
0
% Function does not affect Net Sales Yes = 4
No = 0
2
Clerk sign on method is: Direct entry =
0
Code entry = 1
3
Clerks are: Pop-up = 1
Stay down =
0
4
Enforce closed drawer for register
operation?
Yes = 0
No = 1
Open drawer alarm is active? Yes = 2
No = 0
5
The number of seconds before the open
drawer warning tone sounds (default is 30
seconds).
1-99
6
Allow the post tender function? Yes = 1
No = 0
Drawer is opened on post tender?
Yes = 0
No = 2
Allow multiple receipts? Yes = 4
No = 0
7
Cash declaration is compulsory before
reports may be taken?
Yes = 1
No = 0
Allow negative balance sales in the X
control lock position only?
Yes = 2
No = 0
8
Allow zero balance sales in the X control
lock position only?
Yes = 1
No = 0
Consecutive number is reset after a financial
report?
Yes = 2
No = 0
9
Grand total is reset after a Z Financial
report?
Yes = 1
No = 0
Cash drawer will open when reports are run?
Yes = 0
No = 2
Open drawer during training mode?
Yes = 0
No = 4
10
Decimal place: (0,1,2,3) default=2
0-3