226 • Integrated Payment Appendix SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Reset Mode Procedures
Datatran Function Table
Function Procedure
Initialize EFT
Z-Mode: Enter 500, press SUBTL
Open Batch
Z-Mode: Enter 501, press SUBTL
Close Batch
Z-Mode: Enter 502, press SUBTL
Clear Current Batch
S-Mode: Enter 503, press SUBTL
Change Batch Number
Z-Mode: Enter 504, press SUBTL
Issue Local Total
Z-Mode: Enter 505, press SUBTL
Issue Transaction
Z-Mode: Enter 506, press SUBTL
Issue Batch Status
Z-Mode: Enter 507, press SUBTL
Dial In Load
Z-Mode: Enter 508, press SUBTL
Dial Out Load
Z-Mode: Enter 509, press SUBTL
Tip Entry
Z-Mode: Enter 510, press SUBTL
Pin Pad Initialize
Z-Mode: Enter 511, press SUBTL
Close Batch with Debit
Z-Mode: Enter 512, press SUBTL
DataTran Diagnostics
Z-Mode: Enter 513, press SBTL
Log File Report*
Z-Mode: Enter 514, press SBTL
Voice Authorization
Z-Mode: Enter 515, press SBTL
*The “Log File Report” records each time the “Issue Transaction” (report 506) is generated.
When the “Log File Report” reaches 20 entries, the error message “Log File Full” is
displayed when a “Issue Transaction” (report 506) is attempted. The “Log File Report”
entries clear when the “Log File Report” (report 514) is taken.
To Next Page
Loading...
