Sam4s ER-920 - Group Programming

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 187
Group Programming
99 Group totals are available to accumulate totals of individual PLUs that are assigned to
each group. Each PLU can be assigned to one, two or three different groups. (See "Program
150 - PLU Group Assignment" on page 128 to program PLU groups for each PLU.)
 Use program 900 to assign a group status, i.e. a group can be set to not add to the
total of all groups, or a group can be used to designate like items for kitchen printer
assignment.
 Use program 910 to assign a unique descriptor for each group, so that the group
may be easily understood on the group report.
Program descriptors by typing descriptors on the alpha keyboard overlay or by
entering three digit alpha character codes.
Programming Group Status - Program 900
1. Turn the control lock to the PGM position.
2. To begin the program, enter 9 0 0, press the SUBTL key.
3. Enter the number (1-99) of the group you wish to program; press the X/TIME
key.
4. Enter an option digit from the table below, press the SUBTL key.
Address OPTION VALUE = SUM
N1
Group total is added to the total of all
groups on the Group report?
Yes = 0
No = 1
Send to kitchen printer?
Yes = 2
No = 0
N2
No Choice 0
KP PORT# : R (receipt requisition) 1
KP PORT#: 1 2
KP PORT#: 2 4
N3
KP PORT#: 3
1
KP PORT#: 4
2
N4
Print RED on KP?
Yes = 1
No = 0
N5
Gift Card:
None = 0
Activate = 1
Add = 2
5. To program additional groups, repeat from step 3, or press the CASH key to
finalize the program.
9 0 0 SUBTL
X/TIME
CASH
N5 SUBTLN4 N3 N2 N1