Sam4s ER-920 - Program 1600 - Machine Number Programming; Program 1900 - Starting Kitchen Printer Order Number

202 • P-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Program 1600 - Machine Number Programming
The machine number is printed on the register receipt. Program a machine number so that
any receipt or journal can be identified with the store or register where the transaction took
place.
Programming the Machine Number
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 6 0 0, press the SUBTL key.
3. Enter a machine number (up to 5 digits); press the X/TIME key.
4. Press the CASH key to finalize the program.
Program 1900 – Starting Kitchen Printer Order Number
When using a kitchen printer or requisition receipt, you can program the starting order
number that will appear on the requisition. When a Z1 financial report is taken, the
requisition number will reset and begin again at the number set here.
Programming the Starting KP Order Number
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 9 0 0, press the SUBTL key.
3. Enter the starting number (up to 4 digits); press the X/TIME key.
4. Press the CASH key to finalize the program.
6 0 0 SUBTL1
CASH
X/TIME
9 0 0 SUBTL1
CASH
X/TIME