110 • S-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Application Area Update
7. Continue with the control lock in the S position.
8. Press and hold the Numeral 2 key on the keyboard. While continuing to hold the
Numeral 2 key, turn on the power switch. Immediately, a beep-beep-beep is
heard.
9. Release the Numeral 2 Key.
10. The display will flash (Current program is being erased), after a few seconds, the
display will continue to flash, but at a slower rate. This continues for about 1-
minute while the new program is being loaded. When the load is complete, a
rapid beep-beep-beep will be heard, and the display will flash rapidly. (After
version 1.022 the display will stop flashing to indicate the update is complete.)
11. Power the register OFF. The Flash ROM update is complete.
12. Perform a memory all clear on the ECR. The ECR is now ready to program or to
load a previously saved end-user program.
13. Remove the SD card from the register.
Flash ROM Update by PC
Update Files
To complete the firmware update, you will be supplied with the following files:
NEWNET_DOWN.exe (The update utility program)
ER900.bin
PC Connection Cable
YOU MUST USE Port #1. Use the following cable:
CRS Part # 522120 (Register DB-9MF COM 1 to PC DB-9F)
Update Boot Area
1. Connect the Serial Cable From the ECR to port #1 on your PC.
2. At the register, turn the control lock to the S position.
3. Turn the power switch to the OFF position.
4. Press and hold the CASH and CLERK keys. (Use the keys in their default
locations, the upper-right and lower-right keys on the keyboard.)
5. While continuing to hold the CASH and CLERK keys, turn the power
switch to the ON position. (The display will illuminate and the error tone
will sound beep-beep-beep in quick succession.) Release the keys.
To Next Page
Loading...
