Sam4s ER-920 - Initialize EFT; Clear Curr Batch; Chg Batch Number; Issue Local Total

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 Integrated Payment Appendix • 227
Initialize EFT
Z-Mode: Enter 500, press SUBTL
Select Initialize EFT to verify communications, software versions and installed networks.
DATE 5/24/2011 THU TIME 16:15
** LIST INSTALLED NETWORKS **
VS2 CHK GFT --- VER:6.31
ON ON OFF OFF
CLERK1 000066 00000
Clear Curr Batch
Z-Mode: Enter 503, press SUBTL
The clear batch command erases all the current batch transactions from the Datatran memory
even if they have not been settled. After changing the card masking option (Print Option
#34) A LOCAL TRANSACTION INQUIRY should be printed prior to clearing the batch. This
will ensure that the operator has the transaction detail to re-enter if required.
This operation should only be done under the direction of DATACAP.
Chg Batch Number
Z-Mode: Enter 504, press SUBTL
(At the ENTER BATCH NO message, enter the new number, press CASH.)
The change batch number command is used to assign a new batch number to an existing
batch. It is used with certain credit card processors to rectify settlement problems. It is used
infrequently. (Attempt to change batch number will be denied if bank does not allow the
feature.)
Issue Local Total
Z-Mode: Enter 505, press SUBTL
This report is added for ease of customer balancing actual totals in the Datatran to the system
wide reports. A summary of each kind of credit card and a batch total should match the totals
within the ER-900 report before the Settle Batch is attempted.
DATE 5/24/2011 WED TIME 10:55
****LOCAL TOTAL REPORT ****
AMEX .00 0
VISA 120.32 5
MASTER .00 0
DISCOVER .00 0
PRIVATE LABEL .00 0
DINERS .00 0
JCB .00 0
DEBIT .00 0
TOTAL 120.32 5
CLERK 1 000069 00000
List of Installed Networks
Status of Installed
Software Version