196 • P-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Program 720 – Datatran Message Program
When a Datatran integrated payment appliance is connected, you can print a message of up to
four lines on the electronic payment draft receipt.
1. Turn the control lock to the PGM position.
2. To begin the program, enter 7 2 0, press the SUBTL key.
3. Enter the number of the message line (1-4) you wish to program; press the X/TIME
key.
4. If you are programming using an alpha keyboard overlay, type up to 32 descriptors
on the overlay and press the SUBTL key. (Note: As you are entering descriptors
only the last 16 descriptors will display.)
If you are programming using descriptor codes, enter up to 32 three-character codes
and press the X/TIME key. (See “Descriptor Code Chart” on page 133.)
5. Press the CASH key to finalize the program.
7 2 0 SUBTL
X/TIME
Type up to 32
descriptor keys
SUBTL
SUBTL
Enter up to 32 three-
character codes
CASH
To Next Page
Loading...
