184 • P-Mode Programming SAM4s ER-900 Series Operator's & Programming Manual v.1.28
Clerk Programming
Clerks (which may be used as cashiers), have the following programming options. These
options are set through separate programs:
Program 800 - Secret Code programming determines the code that is used for clerk
sign on if a code entry sign on method is selected in system option #2 (See "System
Option Programming" on page 137.)
Program 801 - If a second cash drawer is installed, Drawer Assignment determines
which cash drawer will be opened for each.
Program 810 - Clerk Descriptor Programming allows you to set a unique, up to 18
character, descriptor for each clerk
Before attempting any programming, all clerks must first be signed off in REG mode.
Program 800 - Secret Code Programming
1. Turn the control lock to the PGM position.
2. To begin the program, enter 8 0 0, press the SUBTL key.
3. Enter the number (1-99) of the clerk you wish to program; press the X/TIME
key.
4. Enter a secret code (up to 6 digits); press the SUBTL key.
5. Repeat from step 3 for each clerk you wish to program. Press the CASH key to
finalize the program.
8 0 0 SUBTL
X/TIME
SUBTL
Enter the secret
code, up to 6
digits
CASH
To Next Page
Loading...
