SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 183
Program 610 – Mix & Match Descriptor Programming
Program descriptors by typing descriptors on the alpha keyboard overlay or by
entering three digit alpha character codes. To enter descriptors by three digit alpha
character codes you must set system option #31 (See “System Option Programming” on
page 137).
1. Turn the control lock to the PGM position.
2. To begin the program, enter 6 1 0, press the SUBTL key.
3. Enter the number (1-99) of the M&M table you wish to program; press the
X/TIME key.
4. If you are programming using an alpha keyboard overlay, type up to 18
descriptors on the overlay and press the SUBTL key. (Note: As you are entering
descriptors only the last 16 descriptors will display.)
If you are programming using descriptor codes, enter up to 18 three-character
codes and press the SUBTL key.
5. Press the CASH key to finalize the program.
X/TIME
6 1 0 SUBTL
CASH
Type up to 18
descriptor keys
SUBTL
SUBTL
Enter up to 18 three-
character codes
To Next Page
Loading...
