Sam4s ER-920 - Miscellaneous Programming; Program 1500 - Macro Key Sequence Programming

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 189
Miscellaneous Programming
Program 1500 - Macro Key Sequence Programming
Macros are special function keys that are used to execute a sequence of key depressions. For
example, a macro might be used to execute a string of reports or to automatically tender a
preset amount. Up to ten different macros may be placed on the keyboard. (See "Function
Key Assignment Programming” on page 99 to place macros on the keyboard.)
To Program a Macro
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 5 0 0, press the SUBTL key.
3. Press the Macro key that you wish to program.
4. You must set the key lock to the position where you wish the macro to set the
register (REG, X or Z.) For example, if you wish the macro to set the key lock
to X to run a report, turn the key lock to X. When used in the REG position, the
macro will set the register to X and run the report.
5. Press up to 50 keystrokes that you wish the macro to execute.
6. Return the key lock to the PGM position and press the macro key to finalize.
7. Repeat from step 3 to program additional macros. Press the CASH key to
finalize the program.
To Remove a Macro
If you wish to change a macro sequence change the function key assignment of the key to
‘Inactive’, and then reassign the macro function and reprogram the keystrokes as shown
above. (See “Function Key Assignment Programming” on page 99.)
5 0 0 SUBTL1
MACRO
CASH
Type up to 50
keystrokes
MACRO