Sam4s ER-920 - Program 400 - PLU Delete Programming

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 135
Program 400 – PLU Delete Programming
NOTE: To delete a PLU, all totals for the PLU must be cleared from both Z1 and Z2
reports and Stock reports.)
1. Turn the control lock to the PGM position.
2. To begin the program, enter 4 0 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
 Press a PLU key on the keyboard or scan the item.
 Press the first PLU key that is to be deleted and press the last PLU key.
 Enter the number of the PLU you wish to delete and press the PLU key.
 Enter the number of the first PLU in a range you wish to delete and press the
PLU key. Enter the last number in the range; press the PLU key.
4. Press X/TIME key.
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
4 0 0 SUBTL
PLU
PLU PLU
PLU
PLU PLU
X/TIME
CASH