Sam4s ER-920 - Program 100 - PLU Status Programming

SAM4s ER-900 Series Operator's & Programming Manual v.1.28 P-Mode Programming • 123
Program 100 - PLU Status Programming
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 0 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
 Press a PLU key on the keyboard or scan the item.
 If sequential PLUs are to receive the same status, press the first PLU key and
then press the last PLU key.
 Enter the number of the PLU (up to 15 digits) and press the PLU key.
 Enter the number of the first PLU in a range of PLUs that are to receive the
same setting; press the PLU key. Enter the last number in the range; press
the PLU key.
4. Refer to the "PLU Status Chart" to determine the values for N1 through N9. (If
an address offers more than one option, add the values for each option and enter
the sum. For example, if you wish the PLU to be taxable by rates 2 and 4, add
the values for your choices, 1 + 4, and enter the sum "5" for address N2.) Enter
the values you have selected, press the X/TIME key. (You do not need to enter
preceding zeros. For example, if you are only selecting a value for N9, just
enter that value.)
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
1 0 0 SUBTL
PLU
PLU PLU
PLU
PLU PLU
CASH
N3 N2 N1 N4 N5 X/TIMEN6 N7 N8 N9