SatLab SLT2 - Page 108

Total Station Manual
-
107
-
B: Press [F1](List) in [Traverse]
screen, use the key [
▲
]\[▼]
to select a Known point in the
point list for traverse
calculation, then press
[F4](OK) to be selected.
[F1](List)
+
[F4](OK)
B: Select the point by list in the
memory.
C: Input the name of known
point and press [F3](Find) to
find whether the point is in
memory, if exist, then press
[F4](OK) to be selected for
calculating; if not exist, then
need to input or measure the
point.
Input name
+
[F3](Find)
+
[F4](OK)
C: Input the name of the point
and find whether it is in memory.
D: Press [F2](Coord.) to input
a known point that not exist
in memory.
[F2](Coord.)
+
Input
Coord.
+
[F4](OK)
D: Input the point through
keyboard.
○
5
After setting known point,
press [ ▼ ]\[▲] key to move
focus to the “AZ”, “ ” and
“Transverse” field, input the
content, then press
[F2](Result) to calculate and
show the traverse result.
[▲]\[▼]
+
Input
content
+
[F2]