SatLab SLT2 - Page 142

Total Station Manual
-
141
-
○
2
In [Define Ref-ARC
method] screen, then press
[F1] or numeric key [1] , enter
[Centre, Start Point] method,
measure Centre point to
define arc.
[F1]
or
[1]
③ There are several methods
to obtain CtrPt which is used
for RefArc definition
A: Enter point name, then
press [F1](ALL) to define the
CtrPt。
Input point
name
+
[F1]
A: Get the target point by measure.
B: Input point name, Press
[F2](DIST) + [F3](REC) to save
the centre point, the saved
result will be directly put into
calculation.
[F2]
+
[F3]
B: Get the target point by DIST+REC.
C: Input point name, press
[F4]( ↓ ) to shift to subscript
function, press [F1](Find) to
check if this point exists, if not
exist, then should firstly input
or measuring this point's
coordinate.
Input point
name
+
[F4]
+
[F1]
+
[F4]
C: Input the name of the point and
find whether it is in memory.