SatLab SLT2 - Page 143

Total Station Manual
-
142
-
D: Press [F2](List) , in [Find Pt.]
dialog, search the known
points in job through [▲]\[▼]
and press [F4](OK) to select.
[F2]
+
[F4]
D: Select the point by list in the
instrument.
E: Press [F3] (Coord.), input
point name, coordinate's data,
it will indicate recover if point
name is repeated, then press
[F4](OK) to save the point.
[F3]
+
Input point
name
coordinate+
[F4]
E: Input the point through keyboard.
④ After measuring centre
point, you can measure the
start point, the definition is
same as centre point. ※
1
[F1]
or
[F2]+[F3]
or
[F4]+[F1]
or
[F4]+[F2]
or
[F4]+[F3]
⑤ After definition of RefArc,
enter interface of [Reference
ARC-Main Page];
Press [F4](Meas.) to enter
[Measure Line&Offset]
interface;
[F4]