SatLab SLT2 - Page 144

Total Station Manual
-
143
-
If it needs to define a new
RefArc , press [F1](NewArc) to
define.
[F1]
※
1
When the centre and start point coincide, the system error reporting "invalid
target data, please input again, select "yes" or press [ESC], return to the
measurement center interface, and restart the definition of arc.
※ In above operation, press [ESC] to return to previous menu.
 Start&End Pt, Angle
Steps
Key
Display
○
1 Press the [F1] or
the numeric key [9] in
the 3/3 page of the
main menu, set the job,
B.S and enter [Reference
Line/ARC] menu, then
press the [F2] or the
numeric key [2] to enter
the definition of RefArc.
[F1]
or
[9]
[F2]
or
[2]