○
2
Input the name of stakeout
point in the Search item. Press
[ENT] to start Find Point function.
(Or input wildcard "*"to start the
wildcard search.)
○
3
A:
The program search the point
name in the job and show the
result dialog. The match points
will be listed, press [F4](OK) to
identify selected point and back
to Stakeout screen. (If the input is
wildcard "*", the program will
show all the points of the current
job.)※
2
B:
If there is no match point in the
job, the program prompts “Pt.
not found!”.And then go in Find
Point In Job screen. User can
input a point or select a point
from another job and then back
to Stakeout screen.
○
4 After finishing setting
stakeout point, start staking out.
※
1
: The settings of job, station and orientation have been elaborated in detail in the
previous chapters, here is no longer repeat. Refer to chapters “Setting The Job、
Setting The Station、Setting The Orientation”.
※
2
: Unlike the other place's points list, the stakeout points are ordered by time. In
To Next Page
Loading...