SatLab SLT2 - Page 76

Total Station Manual
-
75
-
the stakeout points list, the newest point is at the back and the fix point is in the
front of measured point. But in the other points list, the newest point is at the
back and the measured point is in the front of fix point.
 Manual input stakeout point
Press key [Coord.] or [SO-PT] to manual input stakeout point coordinates and
then continue staking out.
[Coord.]:
Press [Coord.] and then input a target point’s coordinates. Saved this point into
job and continue staking out.
Steps
Key
Display
○
1 Press [F4] ( ↓ ) to view the
second page of soft keys.
[F4]
○
2
Press [F2](Coord.) to go to
Input Coord. Screen. Input point
name and coordinate of the
stakeout point. After input one
item, the curser will move to next
input item.
[F2]
+
Input point
name and
coordinates
+
[ENT]
○
3
After finishing inputs, press
[F4](OK) to save the data. And
then back to Stakeout screen.
Start to stakeout the input point.