SatLab SLT2 - Page 79

Total Station Manual
-
78
-
○
2 Press [PAGE] to go to page
1/3(Default page). Press direction
key and move the cursor to input
prism height item. Input the
prism height and then press
[ENT] to confirm.
[PAGE]
+
↓
+
Input prism
height
+
[ENT]
○
3 Aim at the prism. Press
[F2](DIST) to start measuring and
calculate the differences between
measured point and stakeout
point.
[F2]
○
4 Turn the instrument
telescope to make the △ Hz
equal 0 ° 00 ′ 00 ″ and
command the staff to move the
prism at the same time.
Arrows Meaning:
← : Look forward from station
and move the prism to the left.
→ : Look forward from station
and move the prism to the right.
○
5
While the △ Hz equals 0 °
00 ′ 00 ″ , press [F2](DIST) to
start measuring and calculate the
differences between measured
point and stakeout point.
The arrow’s direction is the
direction of the prism need to
move.
[F2]