Total Station Manual
○
4
Aim at the prism. Press
[F2](DIST) to start measuring and
calculate the differences between
measured point and stakeout
point.
○
5
Turn the instrument
telescope to make the △ Hz
equal 0°00’00” and command the
staff to move the prism at the
same time.
△ Hz is positive: The stakeout
point is in the left side of
measured point. Move the prism
to left.
△ Hz is negative: The stakeout
point is in the right side of
measured point. Move the prism
to right.
○
6 Set and aim at the prism in
the direction of △Hz = 0°00’00”.
Press [F2](DIST) to start
measuring and calculate the
differences between measured
point and stakeout point.
△ is positive: The stakeout
point is closer to the station.
Move the prism close to the
station.
△ is negative: The stakeout
point is farther to the station.
Move the prism far away the
station.
To Next Page
Loading...