Total Station Manual
Distance measurement: [F1] (ALL)
or [F1] + [F2] (DIST + REC).
○
9 When finish a known point
measurement, press [F2] (NEXT
PT) to start next known point
measurement. Repeat steps
○
7
and
○
8 .
○
10 If the measured known points
are enough, [Result] will display
on the screen, then press [F3]
(Result) to enter the [Station
Coordinate] to view station
result.
Press [F1] (Back) back to a new
known point measurement.
Press [F2] (errors) to display
standard deviation.
Press [F4] (OK) to set the station
coordinate and instrument
height.
Press [F3] (Result) to enter the
[Station Coordinate] to view
result.
Display standard deviation:
※
1
: The known points can be called from the memory through the [Find], [List] or
manually entered used [Coord.].
To Next Page
Loading...