SatLab SLT2 - Page 94

Total Station Manual
-
93
-
○
2
After finishing setting job,
station and orientation, press [F4]
in the Pre-Setting menu to go to
Select Tie Distance Mode screen.
[F4]
○
3 Press [F1] to select the
Polygonal tie distance.
[F1]
○
4 Start to measure the first
target point. Aim at the first
target point and press [F1](ALL)
or [F2](DIST) + [F3](REC) to
finishing measurement. ※
1`
PAGE1
Press [F1]
or
[F2] + [F3]