SatLab SLT2 - Page 95

Total Station Manual
-
94
-
○
5 Start to measure the second
target point. Aim at the second
target point and press [F1](ALL)
or [F2](DIST) + [F3](REC) to
finishing measurement. ※
1
PAGE1
Press [F1]
or
[F2] + [F3]
○
6 Show the result of polygonal
tie distance.
[NewPt1]: Start a new polygonal
tie distance.
[NewPt2]: This polygonal tie
distance’s second point will be
the new polygonal tie distance’s
first point and then go to
○
5 to
measure the new second target
point.
[Radial]Radial: Go to Radial tie
distance.
※
1
: The target points can be measured, selected from the memory, or input using
the keypad.