92
Prints horizontally to label feed direction
(5) Composition of check digit
Refer to the table below for check digit in each barcode.
[Composition of C/D]
Barcode
specification
parameter
Print digit number and contents
13-digit (Input data of barcode + C/D)
C/D is calculated by modulus10.
13-digit (Input data of barcode) C/D is not checked.
8-digit (Input data of barcode + C/D)
C/D is calculated by modulus10.
8-digit (Input data of barcode) C/D is not checked.
C/D is calculated by modulus47.
C/D is calculated by modulus10.
C/D is calculated by modulus103.
12-digit (Input data of barcode + C/D)
C/D is calculated by modulus10.
GS1-128for
standard carton ID
(UCC/EAN128)
C/D is calculated by modulus103.
[Note] C/D stands for “Check Digit”.
(6) Print Direction of Barcode
Print direction of barcode can be rotated. Note that when specifying Serial 1 and Serial 2 for barcode rotation, it may cause
blurring due to barcode enlargement ratio.
Please avoid 1 dot narrow bar printing. "1 dot is 0.125mm" when the head density is 8dots/mm(203dpi), "1 dot is 0.083mm"
when the head density is 12dots/mm(305dpi), and "1 dot is 0.042mm" when the head density is 24dots/mm(609dpi). 1 dot
narrow bar may lead to unreadability of the barcode.
Parallel 1 : Forward feed print
Parallel 2 : Backfeed print at 180-degree rotation
Parallel 1 : Forward feed print at 90-degree rotation
Parallel 2 : Forward feed print at 270-degree rotation
1) Specify the enlargement ratio of the bar width of the narrow bar for more than 2 dots when printing with Parallel 1 or Parallel 2.
(“L” indicates the enlargement ratio to the bar width ratio.)
2) Specify the enlargement ratio of the bar width of the narrow bar for more than 3 dots when the head density is 8dots/mm or
12dots/mm and printing with Serial 1 or Serial 2.
3) To print with Serial 1 or Serial 2, drop print speed.
To Next Page
Loading...
