238
ESC+YS Registation of Format
Valid range and
term of
command
When the power switch is OFF
The registered data becomes valid.
The set parameter is in effect until a new specification is made.
The set parameter is in effect until a new specification is made.
[Function]
Registering print format.
[Format]
<YS>,aaaaa
●Parameter
aaaaa[Format registration No.] = Valid range : 00001 to 99999
[Coding Example]
<A>
<CC>1
<YS>,1
</N>,3,3
<%>0<V>100<H>200
<P>2<L>0101<XM
>AB
C
<Z>
[Notes]
1.
W
hen
registering
m
ultiple
formats,
Delimit
Start
of
Data
Transmission
<A>
and
End
of
Data
Transmission
<Z>
with
one
format.
2. Specify Card Slot for Use <CC> prior to this command when using.
3. Use this command and Registration of Field </N> as a set.
4. Attempts to re-register with registered No., an error will occur, and the targeted content will be printed.
5. The error occurs when unused or the slot which the printer is allocated is specified (Refer to Card Slot for Use <CC>).
[Valid Commands for Registration]
(Caution) The operation when specified a command that is other than available command is not guaranteed.
[Important]
1. Do not turn the printer power off when accessing to the memory. When the printer power is off while memory accessing, the
data in the accessed media may be corrupted.
2. The maximum registration with </N> is 99 fields. (Refer to the customizable print command of the field registration (ESC+/N)
for the commands can be registered.)
3. The maximum registration with other than </N> is 50 fields. Refer to the customizable print command for the commands can
be registered.)
Registration of Format
To Next Page
Loading...
