SATO s84ex - Other Return Status (Common to Status 3, Status 4, and Status 5)

337
Other return status (Common to Status 3, Status 4, and Status 5) 2.2.5
1) Print configuration request
The printer returns the printer configuration to the host by receiving this command.
(1) Command SOH (01H) + MG
(2) Return status list
No.
Item
Description
Number of
bytes
1
Print method
00H : Thermal transfer
01H : Direct thermal
* Only direct thermal is available in the direct thermal model.
1
2
Print resolution
00H : 8 dots/mm
01H : 12 dots/mm
02H : 24 dots/mm
Model
Range
S84-ex
00H、01H、02H
S86-ex
00H、01H
1
3
Print speed
00H : 2 (inches/sec) 50 (mm/sec)
02H : 3 (inches/sec) 75 (mm/sec)
04H : 4 (inches/sec) 100 (mm/sec)
06H : 5 (inches/sec) 125 (mm/sec)
08H : 6 (inches/sec) 150 (mm/sec)
0AH : 7 (inches/sec) 175 (mm/sec)
0CH : 8 (inches/sec) 200 (mm/sec)
0EH : 9 (inches/sec) 225 (mm/sec)
10H : 10 (inches/sec) 250 (mm/sec)
12H : 11 (inches/sec) 275 (mm/sec)
14H : 12 (inches/sec) 325 (mm/sec)
16H : 13 (inches/sec) 350 (mm/sec)
18H : 14 (inches/sec) 375 (mm/sec)
1AH :15 (inches/sec) 400 (mm/sec)
1CH :16 (inches/sec) 425 (mm/sec)
[S84-ex]
Head density
Range (inches/sec)
8dots/mm (203 dpi)
4 - 16
12dots/mm (305 dpi)
4 - 14
24dots/mm (609 dpi)
2 - 6
[S86-ex]
Head density
Range (inches/sec)
8dots/mm (203 dpi)
4 - 14
12dots/mm (305 dpi)
4 - 12
1
4
Print mode
00H : Continuous
03H : Dispense
04H : Linerless
1
5
Not used
00H : Fixed
1
6
Dispensing
motion
00H : After printing [Motion 1 (Stop position: Head) ]
01H : Before printing [Motion 2 (Stop position: Dispense) ]
02H : No backfeed
1
7
Not used
00H fixed
1
8
Print darkness
Darkness range A (41H) : A
Darkness level 01H : Darkness 1
02H : Darkness 2
03H : Darkness 3
04H : Darkness 4
05H : Darkness 5
06H : Darkness 6
07H : Darkness 7
08H : Darkness 8
09H : Darkness 9
0AH : Darkness 10
2