SATO s84ex - Cleaning and Performing Printer Adjustments

233
Memory Card Command 13
13.1 Memory Card
ESC+CC Card Slot for Use
13.1
ESC+CC
Hexadecimal
code
ESC
CC
Parameter
<1B>16
<43>16<43>16
a
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Specifying the slot No. of the memory card for use.
The printer can access to the media registered to the specified slot.
[Format]
<CC>a
●Parameter
a [Slot No.] = 0 : Slot 0 (Default: printer)
1 : Slot 1 (Default: FROM)
2 : Slot 2 (Default: SD card)
[Coding Example]
<A>
<CC>1
<GI>H003003001FF000000～000000FF
<Z>
[Notes]
1. The allocation of the slot number can be changed from the above default in the memory card mode. Items can be set to
the each slot number are "Printer", "FROM", "SD card", "USB memory", and "Not used." Refer to the Operator Manual
for details.
* "Printer": Printer memory, "FROM": Flash ROM
2. It is necessary to specify when accessing to "FROM", "SD card" and "USB memory."
3. The command error occurs when unused slot is specified.
4. Please confirm that the media is mounted when specifying "SD card" or "USB memory."
The command error occurs when the printer accessed to the slot when the media is not mounted.
[Important]
Do not turn the printer power off when accessing to the memory. When the printer power is off while memory accessing,
the data in the accessed media may be corrupted.
Card Slot for Use