SATO s84ex - Esc+K1 16×16 Dots Vertical Writing Kanji

69
44.1 Font
44.1 ESC+k1 16×16 dots Vertical
Writing Kanji
ESC+k1
Hexadecimal
code
ESC
k1
Parameter
<1B>
16
<6B>
16
<31>
16
an～n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying vertical text flow Kanji font of W16 x H16 dots.
[Format]
<k1>an～n
●Parameter
a[Kanji specification mode] = H : Hexadecimal character
B : Binary code
I : Smoothing function by Hexadecimal character
C : Smoothing function by Binary code
J : Highlight function by Hexadecimal character
D : Highlight function by Binary code
K : Smoothing and highlight functions by Hexadecimal character
E : Smoothing and highlight functions by Binary code
n[Data] = Specify according to the selected Kanji code range
* Printing may not be correct when the number of data is increased/decreased.
[Coding Example] Specified character in HEX, horizontal enlargement: 3 times,
vertical enlargement: 5 times (when KSX1001 is selected)
<A>
<V>100<H>200<P>2<L>0305
<k1>HB0A1B0A2B0A3B0A4B0A5
<Q>2
<Z>
[Notes]
1. Hexadecimal character = 4 bytes ASCII / 1 character
2. Binary code = 2 bytes ASCII / 1 character
3. Smoothing function enlargement scale = Horizontal/Vertical valid range: 3 to 12 times
4. Highlight function enlargement scale = Horizontal/Vertical valid range: 1 to 5 times
[Remarks]
1. In highlight function, the character width will increase based on the enlargement specification.
2. In highlight function, smearing problem may occur depending on the characters.
3. Printable fonts vary according to the font type. Make sure to check if it is printable or not before using.
[Valid Commands]
Print position
<V>
<H>
Modification
<P>
<L>
<%>
<&>
</>
<O>
<WD>
16×16 dots Vertical Writing Kanji