SATO s84ex - ESC+K2 24×24 Dots Horizontal Writing Kanji

66
41.1 Font
41.1 ESC+K2 24×24 dots
Horizontal Writing Kanji
ESC+K2
Hexadecimal
code
ESC
K2
Parameter
<1B>
16
<4B>
16
<32>
16
an～n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying horizontal writing Kanji font of W24 x H24 dots.
[Format]
<K2>an～n
●Parameter
a[Kanji specification mode] = H : Hexadecimal character
B : Binary code
I : Smoothing function by Hexadecimal character
C : Smoothing function by Binary code
J : Highlight function by Hexadecimal character
D : Highlight function by Binary code
K : Smoothing and highlight functions by Hexadecimal character
E : Smoothing and highlight functions by Binary code
n[Data] = Specify according to the selected Kanji code range
* Printing may not be correct when the number of data is increased/decreased.
[Coding Example] Specifying Hex character of Shift JIS, Horizontal enlargement scale: 3 times,
Vertical enlarged scale: 5 times (when KSX1001 is selected)
<A>
<V>100<H>200<P>2<L>0305
<K2> HB0A1B0A2B0A3B0A4B0A5
<Q>2
<Z>
[Notes]
1. Hexadecimal character = 4 bytes ASCII / 1 character
2. Binary code = 2 bytes / 1 character
3. Smoothing function enlargement scale = Horizontal/Vertical valid range: 3 to 12 times
4. Highlight function enlargement scale = Horizontal/Vertical valid range: 1 to 5 times
[Remarks]
1. In highlight function, the character width will increase based on the enlargement specification.
2. In highlight function, smearing problem may occur depending on the characters.
3. Printable fonts vary according to the font type. Make sure to check if it is printable or not before using.
[Valid Commands]
Print position
<V>
<H>
Modification
<P>
<L>
<%>
<&>
</>
<O>
<WD>
24×24 dots
Horizontal Writing Kanji