SATO s84ex - ESC+LD User Download

230
12.14 System
ESC+LD User Download
12.14
ESC+LD
Hexadecimal
code
ESC
LD
Parameter
<1B>
16
<4C>
16
<44>
16
,a,b,c,d,e,f,g,h,i,j
Initial value
Refer to the table below
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Setting the auto-online, availability of zero slash, protocol code and Euro code.
[Format]
<LD>,a,b,c,d,e,f,g,h,i,j
●Parameter
Refer to the table below for the details.
Function
Parameter
Content
Default
Standard
Non-standard
Protocol code
a (Hex)
STX
02H
{ (7BH)
b (Hex)
ETX
03H
} (7DH)
c (Hex)
ESC
1BH
^ (5EH)
d (Hex)
ENQ
05H
@ (40H)
e (Hex)
CAN
18H
! (21H)
f (Hex)
NULL
00H
~ (7EH)
g (Hex)
Offline
40H
] (5DH)
Auto online
h (ASCII)
0 : YES 1 :
NO
0 (30H)
0 (30H)
Zero slash
i (ASCII)
0 : YES 1 :
NO
0 (30H)
0 (30H)
Euro Code
j (Hex)
D5H
D5H
D5H
[Coding Example]
<A>
<LD>,{,},%,#,&,=,~,0,0,<FF>16
<Z>
[Notes]
1. Delimit Start of Data Transmission <A> and End of Data Transmission <Z> with this command for use.
2. Entire or part of parameter entry is omissible by using comma. In this case, comma is not omissible. Omitted setting will
remain as default.
3. If number of commas within parameter is other than 10, or if the specified code is included in the other control code,
command, or print data, operation will not be accurate.
4. Parameter a ~ g of Protocol code will be enabled by setting to Non-standard through Protocol code setting screen in the
Advanced Mode.
5. When a printer receives this command, it prints a list about the protocol code which you set.
6. Restart the printer to enable the settings of this command.
User Download