SATO s84ex - ESC+WN Work Shift Information

38
26.1 Modification
26.1 ESC+WN Work Shift Information
ESC+WN
Hexadecimal
code
ESC
WN
Parameter
<1B>
16
<57>
16
<4E>
16
a,hh,mm,ll,nnn...n
Initial value
1.24.00.1.<space>
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Set the work shift start time and name of the specified work shift code.
[Format]
<WN>a,hh,mm,ll,nnn…n
●Parameter
a = 1, 2 or 3 : shift code
hh = 00 – 24 : shift start time (hours)
mm = 00 – 59 : shift start time (minutes) (when hh=24, 00)
ll = 1-16 : shift name length
nnn…n = <space>, A-Z , 0-9 : shift name maximum 16 characters
[Coding Example]
<A>
<WN>1,08,00,7,MORNING
<Z>
[Notes]
1. The command error occurs when the work shift information is disabled in the closed setting mode of the printer.
2. When the parameter is not specified, the default value will be used.
3. When the length of the sift name (nnn...n) exceeds the value of the length parameter (ll), the exceeded part is cut off.
4. When the length of the sift name (nnn...n) is less than the value of the length parameter (ll), the blank is filled with space.
5. Delimit Start of Data Transmission <A> and End of Data Transmission <Z> with this command to use.
6. This command cannot be used together with <WS> command. When <WN> command and <WS> command is used in
the same label, the work shift information may not be printed correctly.
Work Shift Information