SATO s84ex - ESC+IC Internal Buffer Data Comparison

274
15.5 Intelligent Command
ESC+IC Internal Buffer Data comparison
15.5
ESC+IC
Hexadecimal
code
ESC
IC
Parameter
<1B>
16
<49>
16
<43>
16
a,bb,cc
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Compare the stored data in the internal buffer.
The data after this command will be analyzed when the comparison result is the same as the parameter a (Match/Mismatch).
The data after this command until the data end <Z> will be invalid when the comparison result is not the same as the
parameter a (Match/Mismatch).
[Format]
<IC>a,bb,cc
●Parameter
a[Comparison result] = Valid range : 0 Match
: 1 Mismatch
b[Internal buffer number(original)] = Valid range : 1 ～ 16
c[Internal buffer number(to be compared)] = Valid range : 1 ～ 16
[Coding Example]
<A>
<IC>0,01,02
<V>100<H>400<L>0404<XM>,OK
<Q>1
<Z>
Result)
The below label will be printed when the data are the same.
The label will not be printed when the data is not the same.
[Note]
The command error occurs when the parameter is in invalid range and the comparison of the internal buffer data will not
be done.
Internal Buffer Data
Comparison
Internal buffer
No
Item name
Number of
digits
Data contents
01
DATA1
5
12345
02
DATA2
5
12345
03
DATA3
8
12345678
04
0
.
.
.
.
.
.
.
.
.
.
.
.
16
0
Comparison
OK