SATO s84ex - Operation and Configuration

39
27.1 Modification
27.1 ESC+WS Print of Work Shift
Information
ESC+WS
Hexadecimal
code
ESC
<WS>
Parameter
<1B>
16
<57>
16
<53>
16
a
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying the print of work shift information (Shift code, Start time of printer use, Shift name).
[Format]
<WS>a
●Parameter
a[Data to be printed] = 1: Shift code
2: Start time of printer use
3: Shift name
[Coding Example]
<A>
<XS>
<V>050<H>050<L>0101<XM>SHIFT CODE:
<V>050<H>300<L>0202<WS>1
<V>100<H>050<L>0101<XM>START TIME:
<V>100<H>300<L>0202<WS>2,
<XB>0
<V>150<H>050<L>0101<XM>SHIFT NAME:
<V>150<H>300<L>0101<WS>3
<Q>1
<Z>
(To get work shift information, use the command [SOH+WS])
[Notes]
1. When work shift information is disabled in the Hidden Mode of printer LCD, the command error will occur.
2. To designate the character type of print work shift information, specify the font specification command with no print data
before Work Shift Information <WS>. When not designating the font specification command, the U - character is used for
printing.
3. The font types can be specified are as follows: XU, XS, XM, XB, XL.
4. The font specification command to designate the character type for <WS> is set to the initial value at the next job <A>.
The font specification command that designated print data does not affect the data of <WS>.
5. The details of command to obtain work shift information are as follows.
(1) Command
SOH+WS (01H 57H 53H)
(2) Return status
No.
Item
Bytes
Description
Remarks
-
STX (02H)
1
Status start
a
Shift code
1
"1" / "2" / "3"
b
Shift start time
4
"0000" to "2359"
c
Shift name
1 to 16
-
EXT (03H)
1
Status end
Total
8 to 23
1) Status is returned only when the work shift information is enabled.
2) When receiving this command while setting work shift information, status is returned after finishing its setup.
6. When the calendar setting command <WT> is used together with <WS> command, the work shift information to be printed on
the label is decided according to the new time setting.
7. Only 1 calendar setting command <WT> is valid in the <A><Z> sequence. When a multiple calendar setting command <WT>
is used in one <A><Z> sequence, the last <WT> is used.
Print of Work Shift Information