SATO s84ex - ESC+E Auto Linefeed

227
12.11 System
ESC+E Auto Linefeed
12.11
ESC+E
Hexadecimal
code
ESC
E
Parameter
<1B>
16
<45>
16
aaa
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying line pitch and linefeed.
[Format]
<E>aaa
●Parameter
a[Line pitch width] = Valid range : 0 to 999 dots
[Coding Example]
<A>
<E>10
<V>100<H>200<P>2<L>0304<XM>,ABCDE+CR
FGHIJ+CR
<Q>2
<Z>
[Notes]
1. When CR (0DH) is specified, linefeed based on line pitch will be performed.
2. Rotation <%> is enabled.
3. Line pitch is changeable by this command within items
4. Specify this command before designating the consecutive print of 1-line.
5. Performing auto linefeed by the designation of CR (0DH), print start position of linefeed will be determined based on the
pitch specified with <E> and the value specified with Horizontal Print Position <H> designated after <E>.
In case that <H> is specified several times after <E>, return position by CR (0DH) will be at the end of <H>.
Auto Linefeed