SATO s84ex - ESC+KC Character Code

28
18.1 Modification
18.1 ESC+KC Character Code
ESC+KC
Hexadecimal
code
ESC
KC
Parameter
<1B>
16
<4B>
16
<43>
16
a
Initial value
a=0
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter becomes the initial value at the next item
<A>.
[Function]
Specify the character code.
Normally, the character code is specified in the user mode of the printer, however, the character code can be changed
temporary with this character code command <KC>.
[Format]
<KC>a
●Parameter
a[Character code] = 2 : UTF-16
3 : UTF-8
[Coding Example 1] In case of UTF-8
<A>
<KC>2
<CC>1
<V>100<H>200<P>2<RD>S00,40,40,<E5 B6 B7>
16
<Q>2
<Z>
[Coding Example 2] In case of UTF-16
<A>
<KC>3
<CC>1
<V>100<H>200<P>2<RD>S00,40,40,<5D B7>
16
<Q>2
<Z>
[Notes]
1. This command is not necessary to specify at the normal label printing.
2. This command can be used more than once in the same item.
Character Code