SATO s84ex - ESC+BV MAXI Code (Compatible Commands)

197
10.4 2D code
ESC+BV MAXI Code (Compatible
10.4
Commands)
ESC+BV
Hexadecimal
code
ESC
BV
Parameter
<1B>
16
<42>
16
<56>
16
a,b,c,ddddddddd,eee,fff,n～n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specify the MaxiCode.
[Format]
<BV>a,b,c,ddddddddd,eee,fff,n～n
●Parameter
a[Symbol number] = Range : 1~8
b[Symbol digit] = Range : 1~8
c[Mode] = 2 : For carrier
3 : For carrier
4 : Standard code
6 : For reading device
d [Postal code] = Valid range : 0~999999999 (mode 2)
000000~999999(mode 3)
* Maximum 9 digits for mode 2(only numeric)
Fixed to 6 digits for mode 3 (upper case only for alphabet)
.
e[Country code] = Valid range : 001~999
f [Service class] = Valid range : 001~999
n[Low priority message] = Alphanumeric, symbols
[Coding Example]
<A>
<V>100<H>200<BV>1,1,2,123456789,001,002,SAHTHA
<Q>2
<Z>
[Notes]
1. The size of the MaxiCode does not vary depending on the number of print data.
2. The code will not be printed when a parameter other than above is specified or number of print data does not match.
3. Specify more than 12 for the print data when mode 4 or 6 is specified. The MaxiCode that print data are equal or less than 11
cannot be read by scanners.
[Important]
This command is for existing models. Using Maxi Code command <2D20> is recommended
Mode
Service class
Country code
Postal code
The maximum number of print
data
Numeric only
Alphanumeric
2
Fixed to 3 digits
(Numeric only)
Fixed to 3 digits
(Numeric only)
Maximum 9 digits
123
84
3
Fixed to 6 digits
(alphanumeric)
4
Omission
138
93
6
Maxi Code
(Compatible Commands)