SATO s84ex - ESC+PG Registration of Printer Operation

221
12.9 System
ESC+PG Registration of Printer
12.9
Operation
ESC+PG
Hexadecimal
code
ESC
PG
Parameter
<1B>
16
<50>
16
<47>
16
abcdefghhijklmnooppqqrrstuvwxy
Initial value
Refer to the table below.
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Registering the operation of the printer
[Format]
<PG>abcdefghhijklmnooppqqrrstuvwxy
●Parameter
Refer to the table in the next page for the parameter contents.
[Coding Example]
<A>
<PG><00 00 04 00 00 00 00 41 01 00 00 03 00 00 01 0C 80 03 40 00 00 00 00 00 00 00 00 00 00 00>16
<Z>
Parameter is described in HEX ; <00>16<00>16<04>16・・・・・・<00>16
[Notes]
1. This command is not necessary in the normal label printing operation.
2. Operation settings specified with this command are still in effect after turning off the printer.
3. Do not send the printer operation registration command <PG> during the print operation. The sensor of the printer may
not be disabled if the command <PG> is sent during the print operation.
4. When there is illegal parameter, the command error occurs and the setting is not saved.
[Remark]
The registration of the printer operation can be done in the printer configuration mode and advanced mode in the printer
without using the <PG> command.
Registration of
Printer Operation