SATO s84ex - ESC+F Sequential Numbering

22
13.1 Modification
13.1 ESC+F Sequential Numbering
ESC+F
Hexadecimal
code
ESC
F
Parameter
<1B>
16
<46>
16
aaaabcccc(,dd,ee,f)
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Printing sequential fields (text, barcode) where all incrementing is done within the printer.
[Format]
<F>aaaabcccc(,dd,ee,f)
●Parameter
a[Number of times to repeat the same data] = 1 to 9999
b[Plus or minus symbol] = + :for increments
= - :for decrements
c[Value of step for sequence] = 1 to 9999
d[Sequential numbering digit quantity] = 1 to 99 : If digits are omitted, 8 is default.
e[Number of digits free from sequential numbering] = 0 to 99 : Starting with the rightmost position.
If digits are left out, the default is 0.
f[Decimal/Hex sequential numbering] = 0 : Decimal number. If digits are left out, the default is 0
(zero)
1 : Hexadecimal
[Coding Example] Number of times to repeat the same data: 1, Plus or minus symbol: +
Value of step for sequence: 1, Sequential numbering digit quantity: 5
Number of digits free from sequential numbering: 0
<A>
<V>100<H>100<P>2<L>0202
<F>1+1,5,0<XU>10000
<Q>2
<Z>
[Notes]
1. Up to eight different sequential fields can be specified per label.
2. The print data just after the sequential numbering command <F> is the default value of the sequential numbering data.
3. Specify digits more than sequential numbering digit quantity for the sequential numbering data. When this fails, the
sequential numbering may not be printed correctly.
4. The sequential numbering and inverse printing command <(> cannot be used together.
5. Auto Linefeed <E> is not available.
6. Font or barcode is necessary to be printed in order to implement sequential numbering print.
7. The sequential numbering digit quantity and the digit of data specify command for the font or barcode are needed to be
matched.
When this fails, the sequential numbering cannot be implemented.
8. When the print data just after the sequential numbering <F> is sequential numbering invalid command, the sequential
numbering will be ignored.
[Valid Commands]
Font
<XU>
<XS>
<XM>
<XB>
<XL>
<OA>
<OB>
<RD>
<$=>
<U>
<S>
<M>
<WB>
<WL>
Barcode
<B>
<BC>
<BG>
<BI>
<D>
<D><d>
<BD>
<BT>
<BW>
<BP>
<BF>
<BS>
<BL>
<BL><d>
<BM>
Sequential Numbering