SATO s84ex - ESC+K1(K2) Call of Horizontal Writing External Character

77
50.1 Font
50.1 ESC+K1(K2) Call of Horizontal
Writing External Character
ESC+K1(K2)
Hexadecimal
code
ESC
K1(K2)
Parameter
<1B>
16
<4B>
16
<31>
16
(<4B>
16
<32>
16
)
ab～b
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Recall the horizontal writing external characters registered to the printer memory and print in horizontal writing.
[Format]
<K1>ab～b
<K2>ab～b
●Parameter
a[External character specification mode] = H : Hexadecimal character
B : Binary code
I : Smoothing function by Hexadecimal character
C : Smoothing function by Binary code
J : Highlight function by Hexadecimal character
D : Highlight function by Binary code
K : Smoothing and highlight functions by Hexadecimal character
E : Smoothing and highlight functions by Binary code
b[Registration code] = H，I，J，K : “8021”～“807F”
B，C，D，E : 8021H～807FH
[Coding Example] Recall 16x16 external characters, registration data by HEX characters of GB18030
<A>
<T1>H21
00FF ・・・・・・・・・・FF00
<Z>
<A>
<V>100<H>200<K1>H8021
<Q>2
<Z>
[Notes]
1. If print error occurs, register again.
2. Please specify the slot of the memory to be recalled.
However, data in the internal memory will be recalled when <CC> command is not yet sent after the printer power on.
Call of Horizontal Writing
External Character