104
64.1 ESC+BI GS1-128(UCC/EAN128)
(Standard Carton ID Only)
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
The parameter preset will be invalid.
The parameter preset will be invalid.
[Function]
Specifying GS1-128(UCC/EAN128) barcode for Standard Carton ID.
[Format]
<BI>aabbbcn～n
●Parameter
a[Narrow bar width] = Valid range : 01 to 36 dots
b[Height of barcode] = Valid range : 001 to 999 dots
c[Barcode expository font specification] = 0 :No HRI
1 :HRI is available (Top of barcode)
2 : HRI is available (Bottom of barcode)
n[Print data] = Barcode data (Fixed 17 digits)
Refer to the code list of the GS1-128(UCC/EAN128) for the print data.
EAN128(Barcode for standard carton ID)
- Identifier of sequence code for transportation container
- Package type
- Country code, manufacturer code
- Sequence number of shipment container
- C/D
* Specify the 17 digit data without C/D because C/D is automatically added.
[Coding Example 1] Narrow bar width: 05, barcode height: 080, HRI: yes (in the bottom)
Print data: 12345678901234567
<A>
<V>100<H>200<BI>05080212345678901234567
<Q>2
<Z>
[Coding Example 2] Narrow bar width: 04, barcode height: 150, HRI: no
Print data: 123456789+ calendar data (refer to the enhanced calender printing <WU>)
<A>
<V>100<H>200
<BI>041500<WU>123456789>ZDDMMYYhh>Z
<Q>2
<Z>
[Notes]
1. This is UCC128 code only for the standard carton ID. When printing EAN128 that is used for medical services,
fresh products, and horticultures, please specify the application identifier according to the application, or specify the
print data by separators by using CODE128 barcode command <BG>.
2. Start character code, function character, end character code and identifier (only "00" is supported) are automatically added.
3. Modulus10 check character and modulus 103 check character are automatically produced.
4. Sequential numbering of the barcode data is available.
5. The line pitch between barcode and HRI font is fixed to 10 dots.
6. When the width of the HRI is wider than the barcode width, the HRI is printed from the print start position of the barcode.
7. When the width of the HRI is narrower than the barcode width, the HRI is printed in the center position of the barcode.
8. The font type of the HRI is OCR-B.
9. When the HRI exceeded the printable area, it will not be printed. When barcode with HRI is specified, specify the vertical
position <V> and horizontal position <H> by considering the HRI printing.
10. When other than 0, 1, or 2 is specified as the barcode HRI font, it will be the same as the barcode HRI font specification "0".
GS1-128 (UCC/EAN128)
(Standard Carton ID Only)
To Next Page
Loading...
